Officially recommended physical pad setup imageĪndroid MotionSource server (provide JUST motion data from your phone's sensors).Forum thread with instructions here by epigramx.Nintendo Wii Remotes with Wii MotionPlus (for taping to your regular controller) Try out the BetterJoyForCemu project by Davidobot.You can try this Steam gyro for Cemuhook project by FrogTheFrog.You can verify that all the inputs/mappings are still correct by using XInputTest like before.In case there is red error message about UDP server in Log tab, close any other instances/stop any services of DS4Windows or ScpToolkit Once you start my version up, the Log tab (and the status bar of the window) should say that the UDP server was started. If you never had DS4Windows before, you can extract it anywhere you want (preferably out of program files for UAC reasons).Close any running DS4Windows instances and extract the new version to where you have DS4Windows.exe, overwriting any files when prompted.If you already have DS4Windows setup, it should be working fine when tested with XInputTest.Download the latest version of ryochan DS4Windows fork from their GitHub releases page here.For DS3 controllers, please note that you must plug them in via USB AT LEAST ONCE (meaning that they show up in ScpMonitor/PadTest as connected via USB) so that the calibration data can be downloaded, otherwise gyroscope measurements WILL BE WRONGĭS4Windows (supports DS4 controllers ONLY, but uses the normal USB drivers and the Windows Bluetooth stack).The controllers should sync up and XInputTest should show the same results as last time.Finally, restart the "SCP DSx Service" the same way you stopped it, just click Start in the right-click dropdown menu instead of Stop in services.msc.If you've used Windows Explorer's zip functionality to extract the files, you will have to go to their new location, right click the dll files you've just overwritten, go to Properties, and click the Unblock button, then OK.Then extract the patch archive you downloaded to whereever you installed ScpToolkit to (usually the ScpToolkit folder in your Program Files directory), overwriting any files when prompted.To overwrite the files, you will have to close any running ScpServer windows (check the tray too) and stop the "SCP DSx Service" (accessible by running services.msc from the Windows Run prompt).If that's all good, then download the version of my ScpToolkit patch that matches your ScpToolkit version from my fork's releases page here.After it's setup and detecting your controllers (can verify by running ScpMonitor), test them out with XInputTest.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |